How To Set Up Rcbs Reloading Dies

Faq how much equipment do i need? Intro and clean/inspect cases. Installing the shell holder. Installing the sizer die. Here is how to adjust the resizing die to full length resize cases.

First, run the ram to the top of the reloading press stroke with the proper shell holder installed. Second, screw the resizing die. If you want to full length size a case this is how to set up the die. Place the shell holder into the press ram. Raise the ram to the top.

Screw the die in the top of the press and. Rcbs precisioneered sizer dies for bottleneck cases are vented, when required, to avoid case damage caused by trapped air, and are made to precise tolerances. By following these guidelines for setting up rcbs reloading dies, youll begin your reloading journey on solid ground. Remember to constantly review and refine your setups,. Run the loaded round back up into the die, raise the press handle and check the seating depth again. A few more adjustments may be needed for the proper bullet seating depth; Then, you simply tighten the locknut to secure the bullet seater plug. See our reloading die instructions.